Heating & Furnace Services in Draper, Utah

The widest elevation range of any city we serve

Draper climbs about 1,500 feet from Bangerter Highway to the top of SunCrest. That is more elevation change than any other city in our coverage area. Gas appliances lose about 4 percent of their rated input for every 1,000 feet above 2,000 feet. At upper SunCrest, that works out to a 16 percent derate.

If a furnace was never adjusted for that, it runs rich. The homeowner sees soot, a lazy yellow flame, rough ignition, and igniters that keep failing early. We see this on a large share of SunCrest calls.

Mid-2000s furnaces are reaching their first big failures

SunCrest, Corner Canyon, Mountain Point, and Bellevue filled in during the mid-2000s. Those condensing furnaces are now 15 to 20 years old. That is the age when inducer motors, control boards, and secondary heat exchangers start going.

If your furnace is from that wave, you are in the repair-or-replace window. A written estimate for both is the right ask.

Larger homes often run two furnaces

Homes in Mountain Point, Bellevue, and Draper Heights in the 3,500 to 5,000 square foot range often have two furnaces and two air conditioners in a zoned setup. One zone failing can overload the other.

When you book, tell us you have two systems. The technician plans a longer visit and checks the zoning controls and dampers, not just the furnace that stopped.

Storms on Traverse Ridge affect arrival times

During a multi-day storm, roads on Traverse Ridge can slow access to SunCrest. We dispatch there like anywhere else in Draper, with no extra fee, but arrival windows stretch. If you see a big storm in the forecast and your furnace has been acting up, call before it hits.

Furnace Repair in Draper

Old Draper calls lean toward age-related wear on 80% AFUE furnaces: flame sensors, igniters, blower motors, and vent corrosion. SunCrest and Corner Canyon calls lean toward altitude mismatch and 15-to-20-year-old condensing furnace failures. Partner technicians carry a combustion analyzer and verify gas pressure at your actual elevation on every call. Diagnostic charge is disclosed up front and rolls into the repair invoice once you approve. For the full breakdown, read the full Draper furnace repair guide or the sitewide furnace repair page.

Furnace Installation and Replacement

A furnace install in Draper is only as good as its altitude setup. The installer should fit the manufacturer's high-altitude kit, set manifold pressure for your lot's elevation, and verify with a combustion analyzer before leaving. Two-furnace homes should get both units sized together. Most Draper homes land on a 95% AFUE furnace, which qualifies for the Enbridge Gas ThermWise rebate. See furnace installation in Draper and the furnace replacement decision guide.

Furnace Maintenance and Tune-Ups

Annual maintenance matters most on the ridge, where a furnace that drifted out of altitude spec slowly damages its own heat exchanger. The fall visit covers combustion analysis, gas pressure check, burner cleaning, condensate trap flush, and a look at sidewall vent terminations before snow. Two-furnace homes should have both units serviced in the same visit, with the zoning dampers tested while the technician is there. Details at furnace maintenance in Draper.

Emergency Heating Repair

No-heat calls in Draper get same-day priority, including nights and weekends. Plan for a longer arrival window on Traverse Ridge during an active storm. If you smell gas, leave the house and call Enbridge Gas Utah before calling us. If one zone still heats in a two-furnace home, say so when you call. It changes how urgent the dispatch needs to be. How after-hours dispatch works is covered at emergency heating repair.

Heat Pump and Dual-Fuel Service

Draper is a strong fit for dual-fuel. Newer homes on the ridge already have efficient ductwork and modern thermostats. A cold-climate heat pump paired with the gas furnace cuts gas use through most of the season. The switchover temperature needs to be set for your elevation. Partner technicians repair and tune heat pumps and dual-fuel systems, and Rocky Mountain Power Wattsmart rebates apply to qualifying installs. See heat pump repair.

Boiler Repair

Boilers are rare in Draper. Almost all homes here are forced-air, including the pre-1990 stock in Old Draper. If you do have a boiler or hydronic floor heat in a custom home, our network includes technicians who service them. A hydronic system at SunCrest elevation needs the same altitude-aware combustion tuning as a furnace, so ask for a combustion analysis on any boiler visit. See boiler repair.